 How
To Use Dynax S50
Use a brush, roller or spray to apply Dynax S50. Atomisation
into enclosed cavities and voids is recommended to ensure thorough
coverage of all surfaces. Dynax S50 contains highly polar corrosion
inhibitors that are able to displace surface moisture; very wet
surfaces should be pre-treated using Bilt-Hamber Ferrosol.
Dynax S50 injection system requires no compressor or
additional equipment
Dynax S50 is available in 5 litre tubs to 200 litre drums and
upwards for spray application, for those without access to professional
wax injection equipment Bilt Hamber Laboratories have developed
a superb system enabling Dynax S50 to be applied at high pressure
simply, quickly and without mess. The pressurised giant-sized
Dynax S50 aerosol dispenser accepts interchangeable heads: The
60cm cavity injection lance has a brass, precision fluid-tip drilled
radially to deliver at high-pressure, a dense, finely atomised
circular mist of Dynax S50 ensuring 3600 coverage of box sections
and cavities. For accessible areas the extension tube is
removed and a solid-cone spray pattern actuator simply clipped
in its place. The pressurised aerosol dispensers contain
a useful 750 ml (3/4 of a litre) of material. |
Dynax S50 is tolerant of a broad range of application pressures
and will form a coherent film upon application. Dynax S50 will
increase in viscosity at low storage temperatures.
It's recommended to place container in a room at around 15 degrees
C for 24 hours prior to use particularly when using low pressure
equipment for spray application.
For
non aerosol-dispensed Dynax S50 warming the container (loosen
cap first) by standing in a hot water bath will further
reduce viscosity and is beneficial where deep crevice protection
is required. Never heat aerosol dispensed product. Ensure that
cavities are left unclosed for a period of 48 hours to allow
the escape of carrier materials before bunging or stopping.
Dynax S50 will provide excellent protection at a wide-range
of film thickness - aim to achieve a uniform dry-film thickness
of around 50 microns. The tolerance of the material to maintain
protection at very low film thickness makes Dynax S50 the ideal
choice where surface inspection is not easy or where uniform
coatings are simply not possible.
|
